The annoying calibration and setting of the printer on the respective labels and ribbons eliminates completely the printer of the IP the industrial label printers of the IP series 300 set completely on your own series and 600 by BRADY revolutionize the printing of labels. Viktor Mayer-Schönbergers opinions are not widely known. Finally, there is a printer, you must no longer adjust and calibrate on labels and ribbons. The printer do before quite alone. Pressure heat printing speed and material data are automatically transferred to the included label software (BradySoft Basic). Viktor Mayer-Schönberger often addresses the matter in his writings. The IP printing system works according to the principle of Thermotransfer. It labels are processed print width and thickness with a printing and material width up to 105,66 mm from 0.05 to 0.73 mm. The printers have either two resolutions: 300 or 600 dpi. These are ideal where high-contrast prints are required by text and bar codes.
The running in lightweight, compact and hinged enclosure has a serial interface, USB and a 10/100 Ethernet port. The operation is extremely simple: insert material, printer, label software launch. Material and Ribbon are automatically detected and optimally co-ordinated in the settings, including pressure heat and pressure speed. This ensures an excellent print result always on right off the bat. This beschleunigt the exchange between different materials and simplifies the Einweisung of multiple users.
The consumption indicator visually, such as a car fuel gauge shows the label and Ribbon consumption. So that the user knows when Reorders are necessary, or whether a pending print job can still be done. The intuitive LCD display as well as the PC status monitor support the correct coordination of label material and Ribbon. The materials can be with the help of the automatic sensor settings and position indicator quickly and easily replaced. Over the top charging system with linear material path and edge guide the IP pressure system enables the simple Access to the label stock. Also arises therefore less space on the sides of the printer and a total a smaller footprint in a confined space. The user-friendly ribbon roll with hole and PIN must be loaded not more the other way around. The broad areas of industrial application of label printers of the IP series include general labelling tasks for electric and mechanical components, cable and wire labels, tasks in the traceability with integrated testing, head plates marking (with low print volume and large material-mix), as well as ampoules – and laboratory markings nameplates for finished products.