Allen Software

When sending and viewing video in real time are presented, as a rule, high demands on network bandwidth. For a rational distribution of traffic network video servers network support mechanism of QoS (Quality of Service), which allocates part of the channel in a streaming video of the STS-IPT480. Support for PPPoE (Point-to-Point Protocol over Ethernet) ensures minimal delay and high speed transmission of video and allows you to connect via network video servers ADSL-line or cable modem. Convert analog video signal up to 4 cameras to digital by a processor Arm9, built on the principle of SoC (System-On-a-Chip). Through this network video servers form a high-quality image and transmits it over the network in real time with up to 25 k / s as a quad image of four channels of CIF resolution, or as an image of a selected channel with a resolution up to 720X576 pixels. Thanks to the built-in web server, STS-IPT480 allows you to view digital video on the network through a standard Web browser, Internet Explorer 6.0 and above. Change the settings of the video server can only a user with administrator privileges.

User, not administrator rights, can only view the images in real time and to change the view settings. To connect to the LAN-and WAN-network network video servers are equipped with two network Smartec port 10/100BaseT Ethernet (RJ45). Analog cameras are connected to the STS-IPT480 four composite video inputs, and composite video output via a video server can connect to a monitor for viewing images. Audio Line In and Out devices allow you to organize a two-way audio with the video object. Special attention is paid to the STS-IPT480 protection against deliberate distortion of the video. To do this, network video servers use a technology called Digital Time Code, which exports to all the shots, "watermarks" in the form of the date and time. According to these signs, you can easily determine the exact date and time when the frame was received. In addition to protecting against counterfeit video, this technology helps in the analysis recorded alarm early material.

To work in the video surveillance network video servers are equipped with hardware motion detection and a connector for external alarm sensors. At receiving the alarm STS-IPT480 can send pre-and posttrevozhnye frames specified in the FTP-server, and also activate external alarm devices connected to its alarm outputs. In the supply network video servers STS-IPT480 equipped with Russian-language free software NVR, which supports the simultaneous viewing of "live" video with synchronized audio soundtrack as well as recording and playback of video and audio in MPEG-4. NVR supports all necessary recording modes: continuous, scheduled, motion detection or alarm. Pre-alarm recording the maximum duration of 30 seconds. New network video servers STS-IPT480 already arrived at the warehouse of the company "ARMO-Systems", which is the exclusive distributor of equipment Smartec in Russia and CIS countries, and you can buy them at a retail price of 820 USD, including VAT. For more information on video servers, please e-mail or call (495) 787-33-42 to sales manager. Under the brand name Smartec, a wide range of equipment to create classic and IP-video surveillance systems of any configuration. The product line includes black and white and color cameras, dome cameras, DVRs, IP-cameras, 4 -, 2 – and 1-channel network video servers, software, and widescreen monitors, a camera "day-night" device video transmission via fiber optic lines, brackets, housings, etc.

When sending and viewing video in real time are presented, as a rule, high demands on network bandwidth. For a rational distribution of traffic network video servers network support mechanism of QoS (Quality of Service), which allocates part of the channel in a streaming video of the STS-IPT480. Support for PPPoE (Point-to-Point Protocol over Ethernet) ensures minimal delay and high speed transmission of video and allows you to connect via network video servers ADSL-line or cable modem. Convert analog video signal up to 4 cameras to digital by a processor Arm9, built on the principle of SoC (System-On-a-Chip). Through this network video servers form a high-quality image and transmits it over the network in real time with up to 25 k / s as a quad image of four channels of CIF resolution, or as an image of a selected channel with a resolution up to 720X576 pixels. Thanks to the built-in web server, STS-IPT480 allows you to view digital video on the network through a standard Web browser, Internet Explorer 6.0 and above. Change the settings of the video server can only a user with administrator privileges.

User, not administrator rights, can only view the images in real time and to change the view settings. To connect to the LAN-and WAN-network network video servers are equipped with two network Smartec port 10/100BaseT Ethernet (RJ45). Analog cameras are connected to the STS-IPT480 four composite video inputs, and composite video output via a video server can connect to a monitor for viewing images. Audio Line In and Out devices allow you to organize a two-way audio with the video object. Special attention is paid to the STS-IPT480 protection against deliberate distortion of the video. To do this, network video servers use a technology called Digital Time Code, which exports to all the shots, "watermarks" in the form of the date and time. According to these signs, you can easily determine the exact date and time when the frame was received. In addition to protecting against counterfeit video, this technology helps in the analysis recorded alarm early material.

To work in the video surveillance network video servers are equipped with hardware motion detection and a connector for external alarm sensors. At receiving the alarm STS-IPT480 can send pre-and posttrevozhnye frames specified in the FTP-server, and also activate external alarm devices connected to its alarm outputs. In the supply network video servers STS-IPT480 equipped with Russian-language free software NVR, which supports the simultaneous viewing of "live" video with synchronized audio soundtrack as well as recording and playback of video and audio in MPEG-4. Additional information is available at mywebsearch. NVR supports all necessary recording modes: continuous, scheduled, motion detection or alarm. Pre-alarm recording the maximum duration of 30 seconds. New network video servers STS-IPT480 already arrived at the warehouse of the company "ARMO-Systems", which is the exclusive distributor of equipment Smartec in Russia and CIS countries, and you can buy them at a retail price of 820 USD, including VAT. For more information on video servers, please e-mail or call (495) 787-33-42 to sales manager. Under the brand name Smartec, a wide range of equipment to create classic and IP-video surveillance systems of any configuration. The product line includes black and white and color cameras, dome cameras, DVRs, IP-cameras, 4 -, 2 – and 1-channel network video servers, software, and widescreen monitors, a camera "day-night" device video transmission via fiber optic lines, brackets, housings, etc.

The main advantage of application OnGuard Fire & Intrusion is a single user interface, which is controlled by alarm control panels and central monitoring of the various manufacturers. This software supports devices and alarm panel of well-known companies as Bosch, Digitize, Osbourne-Hoffman and AES-IntelliNet, etc. In addition, each alarm may include an unlimited number of devices that will be served by the program. OnGuard Fire & Intrusion serves a bridge between the standard alarm panels and modules, integrated security system Lenel. This software provides a secondary notification of the alarming developments and help identify places physical location of each sensor and alarm station on the site. Thus, in the event of unauthorized access, OnGuard system to immediately determine the location or source of anxiety and anxiety give the operator instructions about necessary responses. When working with devices and alarm panels from different manufacturers often question the compatibility of data formats.

Within Lenel Integrated security problem is solved by converting all the messages in a single format OnGuard. It is possible to assign a user code conversion, alarm events, depending on configuration panel. OnGuard Fire & Intrusion integrated with the software module OnGuard Central Station Receiver, which is transmitted to all the information from the alarm panel. This module offers a range of additional functions of "alarm – Fire & Intrusion: appointment panels account numbers for their accurate identification, creation of groups of different panels with alarm the possibility of setting common parameters, automatically adding new panels and much more. The program Fire & Intrusion function provides reporting of events that captures the alarm, with the conclusion of their on-screen. At the same time reports can be created by different groups of events to organize the relationship: the loss of communication removal / Arm, performance goals, setting relay output modules, alarm systems, the use of access cards etal. The company Lenel Systems International is one of the world's leading manufacturers of access control and integrated security systems based on them. The platform includes OnGuard: controllers, readers, I / O modules, video recorders, control panels and software access control systems, fire and alarm systems, biometric access control, application access for card printing and more. Lenel Integrated security systems differ in their reliability, efficiency and scalability in a wide range.